MHC1080-41424B Tie-Back Cap Allowable Capacity – 48 Tons

MHC1080-41424B tie-back cap consist of a collar tube with bolt holes for connection to MAGNUM® helical piles and a circular bearing plate with an integrated nut. MAGNUM® products are manufactured in the USA according to our ISO 9001 approved quality program. Structural capacities are developed according to AISC 360 considering an average design life of 75 years for hot-dip galvanized steel in most soil conditions. Bare steel is available upon request. Design and detailing of the structure, to which bearing plate cap is attached varies by project. It is the responsibility of the registered design professional.

Additional information

Allowable Compression/ Tension (Tons)

48 Tons

Ultimate Compression/Tension Tons

97 Tons

Helical Pile Compatibility

https://www.magnumpiering.com/products/mh429u-helical-piles/
https://www.magnumpiering.com/products/mh434u-helical-piles/

Description

Install a MAGNUM® Helical Pile to the correct depth, torque, and capacity. Cut-off the pile shaft at the proper elevation. Drill (3) 1-9/16” holes using the MAGNUM® drill template. Place the pile cap over the shaft and secure with (2) 1-1/4” bolts. Snug tighten nuts. Alternatively, drilling through pile may be omitted and plug welds may be used to secure cap to pile in place of bolts, see MAGNUM® Technical Bulletin TB004. Snug tighten or post-tension thread bar nut against bearing plate as required for the project.

You may also like…